Show Monitor Session - TP-Link T2500G-10TS Cli Reference Manual

3.
4.
Example
Create monitor session 1, then configure port 4, 5, 7 as monitored port and
enable ingress monitoring:
T2500G-10TS(config)#
gigabitEthernet 1/0/4-5,1/0/7 rx
Delete port 4 in monitor session 1 and its configuration:
T2500G-10TS(config)#
gigabitEthernet 1/0/4 rx
25.3

show monitor session

Description
The show monitor session command is used to display the configuration of
port monitoring.
Syntax
show monitor session [
Parameter
session_num
is optional.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the monitoring configuration of monitor session 1:
T2500G-10TS(config)# show monitor session 1
Whether the monitoring port and monitored ports are in the same VLAN
or not is not demanded strictly.
The monitoring port and monitored ports cannot be link-aggregation
member.
session_num
—— The monitor session number, can only be specified as 1. It
monitor session
no monitor session
]
199
1 source interface
1 source interface