Mac-Vlan; Show Mac-Vlan - TP-Link T2500G-10TS Cli Reference Manual

4.2

mac-vlan

Description
The mac-vlan command is used to enable a port for the MAC-based VLAN
feature. Only the port is enabled can the configured MAC-based VLAN take
effect. To disable the MAC-based VLAN function, please use no mac-vlan
command. All the ports are disabled by default.
Syntax
mac-vlan
no mac-vlan
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the Gigabit Ethernet port 1/0/3 for the MAC-based VLAN feature:
T2500G-10TS(config)#interface gigabitEthernet 1/0/3
T2500G-10TS(config-if)#mac-vlan
4.3

show mac-vlan

Description
The show mac-vlan command is used to display the information of the
MAC-based VLAN entry. MAC address and VLAN ID can be used to filter the
displayed information.
Syntax
show mac-vlan { all | mac-address
Command Mode
Privileged EXEC Mode and Any Configuration Mode
mac-addr
| vlan
38
vlan-id
}