Gvrp Timer - TP-Link T2500G-10TS Cli Reference Manual

Example
Configure the GVRP registration mode as "fixed" for Gigabit Ethernet ports
1/0/2-6:
T2500G-10TS(config)#interface range gigabitEthernet 1/0/2-6
T2500G-10TS(config-if-range)#gvrp registration fixed
9.4

gvrp timer

Description
The gvrp timer command is used to set a GVRP timer for the desired port. To
restore to the default setting of a GARP timer, please use no gvrp timer
command.
Syntax
gvrp timer { leaveall | join | leave }
no gvrp timer [leaveall | join | leave]
Parameter
leaveall | join | leave —— They are the three timers: leave All, join and leave.
Once the LeaveAll Timer is set, the port with GVRP enabled can send a
LeaveAll message after the timer times out, so that other GARP ports can
re-register all the attribute information. After that, the LeaveAll timer will start
to begin a new cycle. To guarantee the transmission of the Join messages, a
GARP port sends each Join message two times. The Join Timer is used to
define the interval between the two sending operations of each Join
message. Once the Leave Timer is set, the GARP port receiving a Leave
message will start its Leave timer, and deregister the attribute information if it
does not receive a Join message again before the timer times out.
value
30000 centiseconds and the default value is 1000 centiseconds. The Join
Timer ranges from 20 to 1000 centiseconds and the default value is 20
centiseconds. The Leave Timer ranges from 60 to 3000 centiseconds and
the default value is 60 centiseconds.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
——The value of the timer. The LeaveAll Timer ranges from 1000 to
value
62