User Access-Control Mac-Based - TP-Link T2500G-10TS Cli Reference Manual

Syntax
user access-control ip-based {
[ http ] [ https ] [ ping ] [ all ]
no user access-control
Parameter
ip-addr
set here are allowed for login. 5 IP-based entries can be configured at most.
ip-mask
[ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ] —— Specify the access
interface. These interfaces are enabled by default.
id
—— Delete the specified IP-based entry. The index ranges from 1 to 5.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Enable the access-control of the user whose IP address is 192.168.0.148:
T2500G-10TS(config)#
255.255.255.255
11.4

user access-control mac-based

Description
The user access-control mac-based command is used to limit the MAC
address of the users for login. Only the user with this MAC address you set
here is allowed to login. To cancel the user access limit, please use no user
access-control command.
Syntax
user access-control mac-based {
[ https ] [ ping ] [ all ]
no user access-control
—— The source IP address. Only the users within the IP-range you
—— The subnet mask of the IP address.
user
74
ip-addr ip-mask
} [ snmp ] [ telnet ] [ ssh ]
access-control ip-based
mac-addr
} [ snmp ] [ telnet ] [ ssh ] [ http ]
192.168.0.148