TP-Link T2500G-10TS Cli Reference Manual page 32

Interface Configuration Mode can also be divided into Interface Ethernet, Interface
link-aggregation and some other modes, which is shown as the following diagram.
The following table gives detailed information about the Accessing path, Prompt of each mode
and how to exit the current mode and access the next mode.
Mode Accessing Path
User EXEC
Primary mode once it
is connected with the
Mode
switch.
Use the enable
Privileged
command to enter
this mode from User
EXEC Mode
EXEC mode.
Use the configure
Global
command to enter
Configuration
this mode from
Mode
Privileged EXEC
mode.
Prompt
T2500G-10TS>
T2500G-10TS#
T2500G-10TS(config)#
16
Logout or Access the
next mode
Use the exit command to
disconnect the switch.
Use the enable command to
access Privileged EXEC mode.
Enter the disable or the exit
command to return to User
EXEC mode.
Enter configure command to
access Global Configuration
mode.
Use the exit or the end
command or press Ctrl+Z to
return to Privileged EXEC
mode.
Use the interface
port
gigabitEthernet or
interface range
port-list
gigabitEthernet
command to access Interface
Configuration mode.
vlan-list
Use the vlan to access
VLAN Configuration mode.