Ip Igmp Snooping Filter Maxgroup; Ip Igmp Snooping Filter Mode - TP-Link T2500G-10TS Cli Reference Manual

Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Bind the filtering address ID 2-6 to Gigabit Ethernet port 1/0/3:
T2500G-10TS(config)#interface gigabitEthernet 1/0/3
T2500G-10TS(config-if)#ip igmp snooping filter addr-id 2-6

31.11 ip igmp snooping filter maxgroup

Description
The ip igmp snooping filter maxgroup command is used to specify the
maximum number of multicast groups for a port to join in.
Syntax
ip igmp snooping filter maxgroup
Parameter
maxgroup
It is used to prevent some ports taking up too much bandwidth.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the maximum number of multicast groups for Gigabit Ethernet ports
1/0/2-3 to join in as 10:
T2500G-10TS(config)#interface range gigabitEthernet 1/0/2-3
T2500G-10TS(config-if-range)#ip igmp snooping filter maxgroup 10

31.12 ip igmp snooping filter mode

Description
The ip igmp snooping filter mode command is used to configure the Action
mode for the desired port.
—— The maximum number of multicast groups for a port to join in.
257
maxgroup