TP-Link T2500G-10TS Cli Reference Manual page 33

Mode Accessing Path
Layer 2 Interface:
Use the interface
gigabitEthernet
Interface
or interface range
Configuration
gigabitEthernet
Mode
port-list
enter this mode from
Global Configuration
mode.
Layer 3 Interface:
Use the no
switchport
command to enter
Routed Port mode
from Interface
Configuration mode.
Use the interface
Interface
vlan-id
vlan
command to enter
Configuration
VLAN Interface mode
Mode
from Global
Configuration mode.
Use the interface
loopback
command to enter
Loopback Interface
mode from Global
Configuration mode.
Use the vlan
VLAN
command to enter
Configuration
this mode from
Mode
Global Configuration
mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a Telnet/SSH connection.
2. Each command mode has its own set of specific commands. To configure some
commands, you should access the corresponding command mode firstly.
port,
T2500G-10TS (config-if)#
command to
T2500G-10TS (config-if-range)#
T2500G-10TS (config-if)#
T2500G-10TS(config-if-range)#
id
vlan-list
T2500G-10TS(config-vlan)#
Prompt
or
or
17
Logout or Access the
next mode
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to Global
Configuration mode.
A port number must be
specified in the interface
command.
Use the switchport command
to switch to the Layer 2
interface mode.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to Global
Configuration mode.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit command or the
# command to return to Global
configuration mode.