Qos Queue Dscp-Map - TP-Link T2500G-10TS Cli Reference Manual

Parameter
tag/cos-id
level the packets with tag are mapped to, which ranges from CoS 0 to CoS 7.
tc-id
from 0 to 3, which represents TC0 toTC3 respectively.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
User Guidelines
1.
2.
Example
Map CoS 5 to TC 2:
T2500G-10TS(config)# qos queue cos-map 5 2
24.4

qos queue dscp-map

Description
The qos queue dscp-map command is used to configure the mapping
relation between DSCP Priority and the CoS value. To return to the default
configuration, please use no qos queue dscp-map command. DSCP
(DiffServ Code Point) is a new definition to IP ToS field given by IEEE. This field
is used to divide IP datagram into 64 priorities. When DSCP Priority is enabled,
IP datagram are mapped to different priority levels based on DSCP priority
mode; non-IP datagram with IEEE 802.1Q tag are mapped to different priority
levels based on IEEE 802.1P priority mode if IEEE 802.1P Priority is enabled;
the untagged non-IP datagram are mapped based on port priority mode.
Syntax
qos queue dscp-map {
no qos queue dscp-map
—— The 8 priority levels defined by IEEE 802.1P or the priority
—— The egress queue the packets with tag are mapped to. It ranges
By default, the mapping relation between tag/cos and the egress queue
is:
0/CoS 0-TC1, 1/CoS 1-TC0, 2/CoS 2-TC0, 3/CoS 3-TC1, 4/CoS
4-TC2, 5/CoS 5-TC2, 6/CoS 6-TC3, 7/CoS 7-TC3.
Among the priority levels TC0-TC3, the bigger value, the higher
priority.
dscp-list cos-id
} { }
191