Ip Igmp Snooping Authentication - TP-Link T2500G-10TS Cli Reference Manual

Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the interval of Specific Query Message to 3 seconds in VLAN 2:
T2500G-10TS(config)#
last-member-query-interval 3

31.16 ip igmp snooping authentication

Description
The ip igmp snooping authenticaiton command is used to authenticate the
users who want to join the limited multicast source. To disable the multicast
authentication, please use no ip igmp snooping authentication command.
Syntax
ip igmp snooping authentication
no ip igmp snooping authentication
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
User Guidelines
The IGMP Authentication feature will take effect only when AAA function is
enabled and the RADIUS server is configured. For how to enable AAA function
and configure RADIUS server, please refer to
host.
Example
Enable IGMP authentication on port 1/0/3:
T2500G-10TS(config)# interface gigabitEthernet 1/0/3
T2500G-10TS(config-if)# ip igmp snooping authentication
ip igmp snooping
aaa enable
261
querier vlan 2
and radius-server