Tracert - TP-Link T2500G-10TS Cli Reference Manual

T2500G-10TS# ping 192.168.0.131 –n 8 –l 512
To test the connectivity between the switch and the network device with the
IP fe80::1234, please specify the
milliseconds. If there is not any response after 8 times' Ping test, the
connection between the switch and the network device is failed to establish:
T2500G-10TS# ping fe80::1234 –n 8 –l 512

21.18 tracert

Description
The tracert command is used to test the connectivity of the gateways during
its journey from the source to destination of the test data.
Syntax
tracert [ ip | ipv6 ]
Parameter
ip —— The type of the IP address for tracert test should be IPv4.
ipv6 —— The type of the IP address for tracert test should be IPv6.
ip_addr
is not selected, both IPv4 and IPv6 addresses are supported, for example
192.168.0.100 or fe80::1234.
maxHops
though. It ranges from 1 to 30. By default, this value is 4.
Command Mode
User EXEC Mode and Privileged EXEC Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Test the connectivity between the switch and the network device with the IP
192.168.0.131. If the destination device has not been found after 20
maxHops
failed to establish:
T2500G-10TS# tracert 192.168.0.131 20
ip_addr maxHops
[
—— The IP address of the destination device. If the parameter ip/ipv6
—— The maximum number of the route hops the test data can pass
, the connection between the switch and the destination device is
166
count
(-l) as 512 bytes and
]
count
(-i) as 1000