Loopback-Detection Recover - TP-Link T2500G-10TS Cli Reference Manual

vlan-based
generate an entry on the log file. In addition, the switch will block the VLAN in
which the loop is detected and only the packets of the blocked VLAN cannot
pass through the port.
recovery-mode —— The mode how the blocked port recovers to normal
status.
auto: Block status can be automatically removed after recovery time.
manual
Command Mode
Interface Configuration Mode (interface gigabitEthernet | interface range
gigabitEthernet | interface port-channel | interface range port-channel )
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the loopback detection process-mode as port-based and
recovery-mode as manual for port 2:
T2500G-10TS (config)# interface gigabitEthernet 1/0/2
T2500G-10TS (config-if)# loopback-detection config process-mode
port-based recovery-mode manual
27.6

loopback-detection recover

Description
The loopback-detection recover command is used to remove the block
status of selected ports, recovering the blocked ports to normal status,
Syntax
loopback-detection recover
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
When a loop is detected, the switch will send a trap message and
:
Block status can only be removed manually.
:
205