Ip Igmp Snooping Filter Add-Id - TP-Link T2500G-10TS Cli Reference Manual

Syntax
ip igmp snooping filter
no ip igmp snooping filter
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable IGMP Snooping filter function for Gigabit Ethernet port 1/0/2:
T2500G-10TS(config)#interface gigabitEthernet 1/0/2
T2500G-10TS(config-if)#ip igmp snooping filter

31.10 ip igmp snooping filter add-id

Description
The ip igmp snooping filter add-id command is used to configure the
multicast IP-range desired to filter. To delete the corresponding IP-range,
please use no ip igmp snooping filter add-id command. When IGMP
Snooping is enabled, you can specified the multicast IP-range the ports can
join so as to restrict users ordering multicast programs via configuring
multicast filter rules. Multicast IP addresses ranges from 224.0.0.0 to
239.255.255.255. The range for receivers to join is from 224.0.1.0 to
239.255.255.255.
Syntax
ip igmp snooping filter addr-id
no ip igmp snooping filter addr-id
Parameter
addr-id list
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
addr-id list
—— The filtering address ID to be bound.
256
addr-id list