Chapter 3 Specifications; General Specifications - Mitsubishi Electric NZ2EX2B-60AD4 User Manual

CHAPTER 3
This chapter describes the specifications of the A/D converter module.
3.1

General Specifications

Item
Operating ambient
0 to 55
temperature
Storage ambient
-25 to 75
temperature
Operating ambient
humidity
5 to 95%RH, non-condensing
Storage ambient
humidity
Compliant with JIS
Vibration resistance B 3502 and IEC
61131-2
Shock resistance Compliant with JIS B 3502 and IEC 61131-2 (147m/, 3 times each in X, Y, and Z directions)
Operating
No corrosive gases
atmosphere
*1
0 to 2000m
Operating altitude
Installation location
Inside a control panel
Overvoltage
 or less
*3
category
*4
2 or less
Pollution degree
Equipment class Class 
*1 Do not use or store the A/D converter module under pressure higher than the atmospheric pressure at an altitude of 0
meters. Doing so may cause malfunction. When using the A/D converter module under pressure, please consult your
local Mitsubishi representative.
*2 If the environment satisfies the operating ambient temperature, operating ambient humidity and other conditions, the
module can be used even outside the control panel.
*3 This indicates the assumption that the equipment is connected to which type of power distribution system, from the
public electrical power distribution network down to machinery within premises.
Category  applies to equipment for which electrical power is supplied from fixed facilities. The surge voltage withstand
level for the equipment with up to the rated voltage of 300V is 2500V.
*4 This index indicates the degree to which conductive material is generated in terms of the environment in which the
equipment is used.
In pollution degree 2, only non-conductive pollution occurs. A temporary conductivity caused by condensation must be
expected occasionally.
For compliance with the EMC Directive, refer to "EMC and Low Voltage Directives" in this manual. ( Page 234, Appendix
7)
24
SPECIFICATIONS
Frequency
5 to 8.4Hz
Under intermittent
vibration
8.4 to 150Hz
5 to 8.4Hz
Under continuous
vibration
8.4 to 150Hz
*2
Specifications
Constant
Half amplitude
acceleration

3.5mm

9.8m/

1.75mm

4.9m/
Number of sweeps
10 times each in X,
Y, and Z directions
