Offset/Gain Setting - Mitsubishi Electric NZ2EX2B-60AD4 User Manual

7.3

Offset/Gain Setting

If the user range is necessary, set up the offset/gain setting by following the instructions as illustrated below.
Note that using the factory default range does not require the offset/gain setting.
[User range setting 1 (-10 to 10V)]
CH1: Offset
CH1: Gain
CH2: Offset
CH2: Gain
CH3: Offset
CH3: Gain
CH4: Offset
CH4: Gain
[User range setting 2 (-5 to 5V, -20 to 20mA)]
CH1: Offset
CH1: Gain
CH2: Offset
CH2: Gain
CH3: Offset
CH3: Gain
CH4: Offset
CH4: Gain
1.
Turn off the module power supply.
2.
Set x10 of the station number setting switch to O/G.
3.
Turn on the module power supply and check that
the LEDs are in the following state:
: ON
RUN LED: Off
O/G LED: On
: OFF
4.
Select the setting target using SET/SEL button.
button button
5.
Apply the offset value or gain value to the selected
channel for one second or more.
CHAPTER 7 VARIOUS SETTINGS
83
7