Mitsubishi Electric NZ2EX2B-60AD4 User Manual page 86

● Set up the offset value and the gain value under actual use conditions.
Connection to the CC-Link IE Field Network is not necessary.
● Set up the offset/gain setting in the range satisfying the following condition. If the range is exceeded, the maximum
resolution and accuracy may not fall within the range described in the performance specifications.
• I/O Conversion Characteristics of A/D Conversion ( Page 229, Appendix 4)
● Set values are held and available even after turning off the module power supply because a offset value and a gain value
are written into the non-volatile memory in the main A/D converter module.
● Set up the offset/gain setting so that the offset value is smaller than the gain value.
With Range setting (address: 0103H) set to User range setting 1 or User range setting 2, the main A/D converter module
performs a check on the offset/gain set values when Initial data setting request flag (RY9) is turned on from off. For
invalid condition (offset value ≥ gain value), this check results in the error code (040H) being stored into Latest error
code (RWr0), Error flag (RXA) turning on, and the ERR. LED lighting up.
● The extension A/D converter module does not support user range. Therefore, the offset/gain setting cannot be set up for
the extension A/D converter module.
84
Keep pressing button.
Data is being written.
The write is complete.
6.
Keep pressing  button until the RUN LED lights
up.
Once the RUN LED lights up, release  button. While
the RUN LED lights up, the offset value or gain value is
being written to the non-volatile memory.
After the writing, the RUN LED lights out.
After checking that the RUN LED lights out, go to the
next step.
7.
To set up another channel, go back to step 4.
8.
After setting all the channels to be used, turn off the
module power supply.