(20)CH Scaling lower limit value, CH Scaling upper limit value
Set the range of scale conversion for each channel.
For details on the scaling function, refer to the following:
• Scaling Function ( Page 108, Section 8.11)
(a) Setting range
Setting range: -32000 to 32000 (scaling upper limit value > scaling lower limit value)
(b) Enabling the setting
Turn on and off Initial data setting request flag (RY9) to enable the setting.
(c) Default value
The default value is 0 for all channels.
(d) Remote buffer memory address
The remote buffer memory addresses of this area are as follows:
Remote buffer memory name
CH Scaling lower limit value
CH Scaling upper limit value
● An error occurs in a channel with a set value out of the range or a set value not meeting the following condition: Scaling
upper limit value > Scaling lower limit value. An error results in the error code (090H and 190H, or 091H and
191H) being stored in Latest error code (RWr0), Error flag (RXA) turning on and the ERR. LED lighting up, resulting
operation just before the error.
● By default, 0 is set and so change the set value.
● With Scaling enable/disable setting (address: 0120H, 0220H) set to Disabled (1), the settings of the following areas are
ignored:
• CH Scaling lower limit value
• CH Scaling upper limit value
220
Main A/D converter module
CH1
CH2
CH3
0121H
0123H
0125H
0122H
0124H
0126H
Extension A/D converter module
CH4
CH1
CH2
0127H
0221H
0223H
0128H
0222H
0224H
CH3
CH4
0225H
0227H
0226H
0228H