Mitsubishi Electric NZ2EX2B-60AD4 User Manual page 192

(2) Initial data setting completed flag
After writing parameter data to the remote buffer memory using the REMTO instruction, turn on Initial data setting
request flag (RY9).
Upon completion of the change of operating conditions, Initial data setting completed flag (RX9) turns on.
For the buffer memory areas that require Initial data setting request flag (RY9) to be turned on and off to enable
the written parameter data, refer to the following:
( Page 38, Section 3.7)
*1
Module power supply
Initial data setting completion
flag (RX9)
Initial data setting request
flag (RY9)
Parameter area
*2
Remote READY (RXB)
CH A/D conversion completed
flag
(RX10 to RX13, RX20 to RX23)
*1 For data link to be made at the power-on of the module power supply
*2 When turning on and off Initial data setting request flag (RY9), check that Remote READY (RXB) turns on before starting
the control.
(a) Device number
The device number of this input signal is as follows:
Initial data setting completed flag
190
Controlled by the A/D converter module
Controlled by the program
ON
OFF
OFF
OFF
Reads settings from
the non-volatile memory
(Setting value A)
Starts operation with
the setting value A
ON
OFF
ON
OFF
Signal name
RX9
ON
ON
Setting value change
by user
OFF
OFF
Main A/D converter module
OFF
OFF
(Setting value B)
ON
ON
Extension A/D converter module