Calibration Presets For Cr Conductivity Sensors - JUMO AQUIS touch S Assembly Instructions Manual

15 Calibrating CR conductivity sensors
15.2.2

Calibration presets for CR conductivity sensors

72
Before you can perform a calibration, you must first enter the necessary calibra-
tion default settings. The possible settings for the CR calibration are described
in the following.
Open the calibration default settings:
Device menu > Calibration > Select CR Analysis Input >
Calibration Presets
NOTE!
The "Calibration default settings" menu appears in the Device menu only if a
user with corresponding user rights is logged in.
⇨
Chapter 8.2.1 "Log-on/Log-out", page 91
Sample screen:
CR calibration presets
The calibration default settings enable the calibration routines to be accessed in
the particular calibration menu.
Calibration routines that are not enabled are not visible in the calibration menu.
Additional calibration default settings are explained in the following table.