JUMO AQUIS touch S Assembly Instructions Manual page 33

Configuration point Selection/
a
Compensation
Fixed compensation
a
temperature
Compensation tem-
perature
Temperature input fil-
a
ter time
a
Temperature offset
a
This setting is saved in the configuration of the JUMO digiLine electronics.
b
The unit for the item set in "Parameter" appears in the entry field.
setting option
Fixed compensation temperature
Sensor temperature
Interface
-25 to+150 °C
Selection from Analog selection
0 to 25 s
-10 to+10 °C
10 Configuration
Explanation
For pH sensors only:
Selection of the signal source for
temperature compensation in the
JUMO digiLine electronics
Fixed compensation temperature:
Compensation with a fixed tempera-
ture value that is entered in the con-
figuration item "Compensation
temperature".
Sensor temperature: The integrat-
ed temperature probe of the pH sen-
sor supplies the compensation
temperature.
Interface: The AQUIS touch S trans-
mits the compensation temperature
to the JUMO digiLine electronics via
the serial interface. The source of the
compensation temperature is set in
the configuration point "Compensa-
tion temperature".
only if "Compensation" is set to
"Fixed compensation tempera-
ture":
constant temperature value, for tem-
perature compensation of the pH val-
ue measurement in the JUMO
digiLine electronics
only if "Compensation" is set to
"Interface":
Selection of the signal source from
the Analog selection of the JUMO
AQUIS touch S for temperature com-
pensation of the pH value measure-
ment in the JUMO digiLine
electronics
Optimization of measured tempera-
ture value updating in the JUMO dig-
iLine electronics
The higher the value of the filter time
const., the slower the measured val-
ue is updated.
Correction value that is added to the
measured temperature value
33