Table of Contents
Advertisement
10 Configuration
CR/Ci measuring range configuration
Configuration point Selection/
TDS factor
Compensation
Unit for
calculation
Unit
26
Open: Device Menu > Configuration > Analog Inputs >
Analysis Input 1 to 4 > Measuring Range 1 to 4
setting option
0.01 to 2.00
for CR/Ci:
Off,
TC linear,
natural water,
natural water with
expanded temperature
range
only for CR:
TDS,
ASTM neutral,
ASTM acid,
ASTM alkaline
only for Ci:
TC curve,
NaOH 0 to 12 %,
NaOH 25 to 50 %,
HNO3 0 to 25 %,
HNO3 36 to 82 %,
H2SO4 0 to 28 %,
H2SO4 36 to 85 %,
H2SO4 92 to 99 %,
HCL 0 to 18 %,
HCL 22 to 44 %
for CR/Ci:
µS/cm
mS/cm
only for CR:
kΩ/cm
MΩ/cm
up to 5 text characters
Explanation
only for conductive conductivity with
TDS compensation:
Conversion factor from measured conductivity to
display unit (see configuration item "Unit" in this
table)
Type of temperature compensation for conduc-
tivity measurement
Unit in which the conductivity is displayed
only for conductive conductivity measure-
ment with
TDS compensation:
Unit for the process variable to be displayed for
TDS measurements or when using customer-
specific linearization (e.g. ppm or mg/l)
Advertisement
Table of Contents
