JUMO AQUIS touch S Assembly Instructions Manual page 35

Configuration point Selection/
Start of display range -99999 to +99999
Display range end
Sampling rate
Filter Time Constant
a
The unit set as the unit in "Oxygen unit" appears in the entry field.
For JUMO ecoLine NTU sensors only
Configuration point Selection/
Turbidity measuring
range
Turbidity unit
Decimal place
Filter Time Constant
Start of display range -99999 to +99999
Display range end
a
The unit set as the unit in "Turbidity unit" appears in the entry field.
setting option
a
a
-99999 to +99999
1 to 999 s
0 to 25 s
setting option
automatic
0 to 50 NTU
0 to 200 NTU
0 to 1000 NTU
0 to 4000 NTU
NTU
FNU
Fixed comma format
0 to 25 s
a
a
-99999 to +99999
10 Configuration
Explanation
Upper/lower limit for labeling the
scale when displaying measured val-
ues, e.g. in recorder diagrams and
bar graphs
Indication of the length of the interval
between 2 measurements
A slower "sampling rate" contributes
to a longer operating life of the sen-
sor.
With faster "sampling rates, the mea-
sured value is updated frequently.
Optimization of measured value up-
dating in the JUMO digiLine electron-
ics
The higher the value of the filter time
const., the slower the measured val-
ue is updated.
Explanation
Selection of the measuring range for
the turbidity measurement
The user can choose a fixed measur-
ing range or automatic measuring
range selection.
Selection of the unit in which the
measured turbidity value is dis-
played.
Decimal points in the display
Optimization of measured value up-
dating in the JUMO digiLine electron-
ics
The higher the value of the filter time
const., the slower the measured val-
ue is updated.
Upper/lower limit for labeling the
scale when displaying measured val-
ues, e.g. in recorder diagrams and
bar graphs
35