HPE FlexNetwork 5130 HI Series Network Management And Monitoring Command Reference page 101

Root roundtrip delay: 0.0000ms, root dispersion: 0.0000ms
Reachabilities:0, sync distance: 15.938
Precision: 2^10, version: 4, source interface: Not specified
Reftime: 00000000.00000000
Orgtime: d17cbb21.0f318106
Rcvtime: 00000000.00000000
Xmttime: 00000000.00000000
Roundtrip delay samples: 0.000 0.000 0.000 0.000 0.000 0.000 0.000 0.000
Offset samples: 0.00
Filter order: 0
Total sessions: 1
Table 16 Command output
Field
Clock source
Clock stratum
Clock status
Thu, Feb 7 2036
Tue, May 17 2011
Thu, Feb 7 2036
Thu, Feb 7 2036
0.00 0.00 0.00
1 2 3 4
Description
IPv6 address of the clock source. If this field displays ::, the IPv6
address of the NTP server has not been resolved successfully.
Stratum level of the NTP server, which determines the clock
precision. The value is in the range of 1 to 16. A lower stratum
level represents higher clock accuracy. A stratum 16 clock is not
synchronized and cannot be used as a reference clock.
Status of the clock source corresponding to this association:
• configured—The association was created at the CLI.
• dynamic—The association is established dynamically.
• master—The clock source is the primary reference source
of the current system.
• selected—The clock source has survived the clock selection
algorithm.
• candidate—The clock source is the candidate reference
source.
• sane—The clock source has passed authentication and will
be used as a reference clock.
• insane—The clock source has not passed authentication, or
it has passed authentication but will not be used as a
reference clock.
• valid—The clock source is valid, which means the clock
source meets the following requirements:
• invalid—The clock source is invalid.
• unsynced—The clock source has not been synchronized or
the value of the stratum level is invalid.
92
6:28:16.000
9:15:13.059
6:28:16.000
6:28:16.000
0.00 0.00 0.00
5 6 7
It has been authenticated and synchronized.
Its stratum level is valid.
Its root delay and root dispersion values are within their
ranges.
0.00