Source Ipv6 - HPE FlexNetwork 5130 HI Series Network Management And Monitoring Command Reference

If you execute the source interface and source ip commands multiple times for an ICMP echo
operation, ICMP template, or UDP tracert operation, the most recent configuration takes effect.
Examples
# Specify 10.1.1.1 as the source IPv4 address for ICMP echo requests.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source ip 10.1.1.1
# In ICMP template view, specify 10.1.1.1 as the source IPv4 address for ICMP echo requests.
<Sysname> system-view
[Sysname] nqa template icmp icmptplt
[Sysname-nqatplt-icmp-icmptplt] source ip 10.1.1.1
Related commands
source interface

source ipv6

Use source ipv6 to configure the source IPv6 address for probe packets.
Use undo source ipv6 to restore the default.
Syntax
source ipv6 ipv6-address
undo source ipv6
Default
The probe packets takes the IPv6 address of their output interface as the source IPv6 address.
Views
ICMP echo operation view
Any NQA template view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies the source IPv6 address for probe packets. IPv6 link-local addresses are not
supported.
Usage guidelines
The specified source IPv6 address must be the IPv6 address of a local interface. The local interface
must be up. Otherwise, no probe packets can be sent out.
For an NQA template, if the source and destination addresses have different IP versions, the source
address does not take effect.
If you execute the source interface and source ipv6 commands multiple times for an ICMP echo
operation or ICMP template, the most recent configuration takes effect.
Examples
# Specify 1::1 as the source IPv6 address for the ICMP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
76