HPE FlexNetwork 5130 HI Series Network Management And Monitoring Command Reference page 319

Default
No source port is configured for a mirroring group.
Views
System view
Predefined user roles
network-admin
Parameters
group-id: Specifies a mirroring group by its number. The specified mirroring group must already exist.
The value range for this argument is 1 to 4.
interface-list: Specifies a space-separated list of up to eight interface items. Each item specifies an
interface by its type and number or specifies a range of interfaces in the form of interface-type
interface-number1 to interface-type interface-number2. When you specify a range of interfaces, the
interfaces must be of the same type and on the same slot. The start interface number must be
identical to or lower than the end interface number.
both: Mirrors both received and sent packets.
inbound: Mirrors only received packets.
outbound: Mirrors only sent packets.
Usage guidelines
You can configure source ports only for local mirroring groups and remote source groups.
A Layer 2 interface cannot be configured as a source port for a mirroring group.
Do not assign a source port of a mirroring group to the remote probe VLAN of the mirroring group.
A port can be assigned to different mirroring groups as follows:
• When acting as a source port for unidirectional mirroring, the port can be assigned to up to four
mirroring groups.
• When acting as a source port for bidirectional mirroring, the port can be assigned to up to two
mirroring groups.
• When acting as a source port for unidirectional and bidirectional mirroring, the port can be
assigned to up to three mirroring groups. One mirroring group is used for bidirectional mirroring
and the other two for unidirectional mirroring.
A source port cannot be used as a reflector port, monitor port, or egress port.
Examples
# Create local mirroring group 1 to monitor the bidirectional traffic of GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] mirroring-group 1 local
[Sysname] mirroring-group 1 mirroring-port gigabitethernet 1/0/1 both
# Create remote source group 2 to monitor the bidirectional traffic of GigabitEthernet 1/0/2.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] mirroring-group 2 mirroring-port gigabitethernet 1/0/2 both
Related commands
mirroring-group
310