Reaction Checked-Element { Jitter-Ds | Jitter-Sd - HPE FlexNetwork 5130 HI Series Network Management And Monitoring Command Reference

[Sysname-nqatplt-http-httptplt] raw-request
[Sysname-nqatplt-http-httptplt-raw-request] POST /sdn/ui/app/index HTTP/1.0\r\nHost:
172.0.0.2\r\nAuthorization: Basic cm9vdDoxMjM0NTY=\r\n\r\n

reaction checked-element { jitter-ds | jitter-sd }

Use reaction checked-element { jitter-ds | jitter-sd } to configure a reaction entry for monitoring
one-way jitter in the NQA operation.
Use undo reaction to delete a reaction entry.
Syntax
reaction item-number checked-element { jitter-ds | jitter-sd } threshold-type { accumulate
accumulate-occurrences
[ action-type { none | trap-only } ]
undo reaction item-number
Default
No reaction entries for monitoring one-way jitter exist.
Views
ICMP jitter/UDP jitter/voice operation view
Predefined user roles
network-admin
Parameters
item-number: Assigns an ID to the reaction entry, in the range of 1 to 10.
jitter-ds: Specifies the destination-to-source jitter of each probe packet as the monitored element (or
performance metric).
jitter-sd: Specifies source-to-destination jitter of each probe packet as the monitored element.
threshold-type: Specifies a threshold type.
accumulate accumulate-occurrences: Checks the total number of threshold violations in the
operation. The value range is 1 to 14999 for the ICMP jitter and UDP jitter operations, and 1 to 59999
for the voice operation.
average: Checks the average one-way jitter.
threshold-value: Specifies threshold range in milliseconds.
upper-threshold: Specifies the upper limit in the range of 0 to 3600000.
lower-threshold: Specifies the lower limit in the range of 0 to 3600000. It must not be greater than the
upper limit.
action-type: Specifies the action to be triggered. The default action is none.
none: Specifies the action of displaying results on the terminal display.
trap-only: Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS.
Usage guidelines
You cannot edit a reaction entry after it is created. To change the attributes in a reaction entry, use
the undo reaction command to delete the entry, and then configure a new one.
Only successful probe packets are monitored. Statistics about failed probe packets are not collected.
| }
average threshold-value
59
upper-threshold lower-threshold