Display Poe Interface Power - HPE FlexNetwork 5130 HI Series Network Management And Monitoring Command Reference

GE1/0/48
--- On State Ports: 0; Used: 0.0(W); Remaining: 180.0(W)
Table 25 Command output
Field
Interface
PoE
Priority
CurPower
Oper
IEEE Class
Detection Status
On State Ports
Used
Remaining

display poe interface power

Use display poe interface power to display power information for PIs.
Syntax
display poe interface power [ interface-type interface-number ]
Disabled Low
Description
Interface name of a PI.
PoE status:
•
•
Power priority of a PI:
•
•
•
Current power of a PI.
Operating status of a PI:
•
•
•
•
•
•
PD power class: 0, 1, 2, 3, or 4.
If the PSE does not support PD classification, this field displays a
hyphen (-).
Power detection status of a PI:
•
•
•
•
•
•
•
Number of PIs that are supplying power.
Power consumed by the current PI.
Total remaining power of the system.
0.0 Off
Enabled.
Disabled.
Critical (highest).
High.
Low.
Off—PoE is disabled.
On—Power is being supplied to the PI correctly.
Power-lack—Remaining guaranteed power is insufficient for a
critical PI.
Power-deny—The PSE refuses to supply power. The power
required by the PD is higher than the configured power.
Power-itself—The PD is using another power supply.
Power-limit—The PSE is supplying power to the PD based on
the configured power though the PD requires more power than
the configured power.
Disabled—PoE function is disabled.
Searching—The PI is searching for the PD.
Delivering Power—The PI is supplying power for the PD.
Fault—A fault occurred during the test.
Test—The PI is undergoing a test.
Other fault—A fault has caused the PSE to enter the idle status.
PD disconnected—The PD is disconnected.
135
0 Disabled
---