Ntp-Service Max-Dynamic-Sessions - HPE FlexNetwork 5130 HI Series Network Management And Monitoring Command Reference

Parameters
server-name: Specifies an NTP server by its host name, a case-insensitive string of 1 to 253
characters.
ipv6-address: Specifies an NTP server by its IPv6 address. It must be a unicast address, rather than
a multicast address.
authentication-keyid keyid: Specifies the key ID to be used for sending NTP messages to the NTP
server. The value range for the keyid argument is 1 to 4294967295. If you do not specify this option,
the local device and NTP server do not authenticate each other.
priority: Specifies this NTP server as the first choice under the same condition.
source interface-type interface-number: Specifies the source interface for IPv6 NTP messages. If
the specified IPv6 NTP server address is not a link local address, the source IPv6 address for IPv6
NTP messages sent by the local device to the NTP server is the IPv6 address of the specified source
interface. If the specified IPv6 NTP server address is a link local address, the IPv6 NTP messages
are sent from the specified source interface, and the source address of the messages is the link local
address of the interface. The interface-type interface-number argument represents the interface type
and number. If you do not specify an interface, the device automatically selects the source IPv6
address of IPv6 NTP messages. For more information, see RFC 3484.
Usage guidelines
When you specify an IPv6 NTP server for the device, the device is synchronized to the IPv6 NTP
server, but the IPv6 NTP server is not synchronized to the device.
Examples
# Specify the IPv6 NTP server 2001::1 for the device.
<Sysname> system-view
[Sysname] ntp-service ipv6 unicast-server 2001::1
Related commands
ntp-service authentication enable
ntp-service authentication-keyid
ntp-service reliable authentication-keyid

ntp-service max-dynamic-sessions

Use ntp-service max-dynamic-sessions to set the maximum number of dynamic NTP sessions.
Use undo ntp-service max-dynamic-sessions to restore the default.
Syntax
ntp-service max-dynamic-sessions number
undo ntp-service max-dynamic-sessions
Default
The maximum number of dynamic NTP sessions is 100.
Views
System view
Predefined user roles
network-admin
Parameters
number: Sets the maximum number of dynamic NTP associations, in the range of 0 to 100.
115