Reaction Checked-Element Mos - HPE FlexNetwork 5130 HI Series Network Management And Monitoring Command Reference

trap-only: Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS.
Usage guidelines
You cannot edit a reaction entry after it is created. To change the attributes in a reaction entry, use
the undo reaction command to delete the entry, and then configure a new one.
Examples
# Create reaction entry 1 for monitoring the ICPIF value in the voice operation, and set the upper limit
to 50 and lower limit to 5. Before the voice operation starts, the initial state of the reaction entry is
invalid. After the operation, the ICPIF value is checked against the threshold range. If it exceeds the
upper limit, the state of the reaction entry is set to over-threshold. If it is below the lower limit, the
state is set to below-threshold. Once the state of the reaction entry changes, a trap message is
generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type voice
[Sysname-nqa-admin-test-voice] reaction 1 checked-element icpif threshold-value 50 5
action-type trap-only

reaction checked-element mos

Use reaction checked-element mos to configure a reaction entry for monitoring the MOS value in
the voice operation.
Use undo reaction to delete a reaction entry.
Syntax
reaction item-number checked-element mos threshold-value upper-threshold lower-threshold
[ action-type { none | trap-only } ]
undo reaction item-number
Default
No reaction entries for monitoring the MOS value exist.
Views
Voice operation view
Predefined user roles
network-admin
Parameters
item-number: Assigns an ID to the reaction entry, in the range of 1 to 10.
threshold-value: Specifies threshold range.
upper-threshold: Specifies the upper limit in the range of 1 to 500.
lower-threshold: Specifies the lower limit in the range of 1 to 500. It must not be greater than the
upper limit.
action-type: Specifies what action to be triggered. The default action is none.
none: Specifies the action of displaying results on the terminal display.
trap-only: Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS.
62