PD Description
Table 24 Command output
Field
PoE Status
Power Priority
Oper
IEEE Class
Detection Status
Power Mode
Current Power
Average Power
Peak Power
Max Power
Electric Current
Voltage
PD Description
# Display power supplying information for all PIs.
<Sysname> display poe interface
Interface
PoE
: IP Phone For Room 101
Description
PoE status:
•
Enabled.
•
Disabled.
Power supply priority of the PI:
•
Critical (highest).
•
High.
•
Low.
Operating status of a PI:
•
Off—PoE is disabled.
•
On—Power is being supplied to the PI correctly.
•
Power-lack—Remaining guaranteed power is insufficient for a
critical PI.
•
Power-deny—The PSE refuses to supply power. The power
required by the PD is higher than the configured power.
•
Power-itself—The PD is using another power supply.
•
Power-limit—The PSE is supplying power to the PD based on
the configured power though the PD requires more power than
the configured power.
PD power class: 0, 1, 2, 3, or 4.
If the PSE does not support PD classification, this field displays a
hyphen (-).
Power detection status of a PI:
•
Disabled—The PoE function is disabled.
•
Searching—The PI is searching for the PD.
•
Delivering power—The PI is supplying power to the PD.
•
Fault—A fault occurred during the test.
•
Test—The PI is undergoing a test.
•
Other fault—A fault has caused the PSE to enter the idle status.
•
PD disconnected—The PD is disconnected.
Power transmission mode of a PI. Signal represents that power is
being supplied over signal cables.
Current power of a PI, including PD consumption power and
transmission loss.
Average power of a PI.
Peak power of a PI.
Maximum power of a PI.
Current of a PI.
Voltage of a PI.
Type and location description for the PD connected to the PI.
Priority
CurPower
133
Oper
IEEE
Detection