Table of Contents
Advertisement
4.4.3 Recording Duration
To configure the triggering current threshold of the True InRush
1. In the OFF position, hold the
switch to
of a beep, to enter the configuration mode. The display will then
indicate the recording interval.
NOTE:
The default value is 60 sec. Possible values range from
( 1 to 600) sec (10 mins).
2. To change the recording interval, press the
hand digit blinks. Each press on the
To go to the next digit, apply a long press (> 2 sec) to the
3. When the desired unit is displayed, turn the switch to another setting.
The unit chosen is stored and a double beep is emitted.
4.4.4 Erasing Recordings from Memory
To erase a recording from memory, perform the following:
NOTE:
Make sure there is no voltage on the input terminals.
1. In the OFF position, hold the
switch to
2. The device emits a beep after erasing the records in memory. The rSt
and rEC symbols are displayed.
3. The device then switches to normal continuity measurement.
4.4.5 Default Configuration
To reset the clamp-on meter to its default parameters (factory configuration):
1. In the OFF position, hold the
switch to
emitted. The rSt symbol is displayed.
2. After 2 sec, the clamp-on meter emits a double beep, then all of the
digital symbols of the screen are displayed until the
released. The default parameters are then restored:
ƒ Recording interval = 60 s
ƒ Continuity detection threshold = 40
ƒ True InRush
Clamp-On Meter Model 607- User Manual
until the end of the full screen display and the emission
.
, until the full screen display ends and a beep is
triggering threshold = 10 %
®
button down while turning the
button. The right-
button increments its value.
button down while turning the
button down while turning the
Ω
measurement:
®
button.
button is
27
Advertisement
Table of Contents
