Keypad Operation - Salicru CV10-002-S2 User Manual

4.2.2 Displayed state of running parameters
After the inverter receives valid running commands, the inverter will enter into the running state and the keypad
will display the running parameters. RUN/TUNE LED on the keypad is on, while the FWD/REV is determined by
the current running direction which is shown as figure 4-2.
In the running state, there are 22 parameters can be selected to be displayed or not. They are: running
frequency, set frequency, bus voltage, output voltage, output torque, PID reference, PID feedback, input
terminals state, output terminals state, and the current stage of multi-step speeds, pulse counting value, AI1,
AI2, percentage of motor overload, percentage of inverter overload, linear speed. P07.05 and P07.06 can
select the parameter to be displayed or not by bit and 》/SHIFT can shift the parameters from left to right,
QUICK/JOG (P07.02=2) can shift the parameters from right to left.
4.1.3 Displayed state of fault
If the inverter detects the fault signal, it will enter into the fault pre-alarm displaying state. The keypad will
display the fault code by flicking. The TRIP LED on the keypad is on, and the fault reset can be operated by the
STOP/RST on the keypad, control terminals or communication commands.
4.1.4 Displayed state of function codes editing
In the state of stopping, running or fault, press PRG/ESC
see P07.00 ).The editing state is displayed on two classes of menu, and the order is: function code
group/function code number→function code parameter, press DATA/ENT into the displayed state of function
parameter. On this state, press DATA/ENT to save the parameters or press PRG/ESC to escape.

4.2 Keypad operation

Operate the inverter via operation panel. See the detailed structure description of function codes in the brief
diagram of function codes.
4.2.1 How to modify the function codes of the inverter
The inverter has three levels menu, which are:
1. Group number of function code (first-level menu)
2. Tab of function code (second-level menu)
3. Set value of function code (third-level menu)
Remarks: Press both the PRG/ESC and the DATA/ENT can return to the second-level menu from the
third-level menu. The difference is: pressing DATA/ENT will save the set parameters into the control panel, and
then return to the second-level menu with shifting to the next function code automatically; while pressing
PRG/ESC will directly return to the second-level menu without saving the parameters, and keep staying at the
current function code.
Under the third-level menu, if the parameter has no flickering bit, it means the function code cannot be modified.
The possible reasons could be:
1) This function code is not modifiable parameter, such as actual detected parameter, operation records and so on;
20 - 104
to enter into the editing state (if there is a password,
Figure 4-2 Displayed state
Keypad Operation Procedure