Salicru CV10-002-S2 User Manual page 13

Environment
Altitude
Vibration
Installation direction
Note:
 CV10 inverters should be installed in a clean and ventilated environment according to enclosure
classification.
 Cooling air must be clean, free from corrosive materials and electrically conductive dust.
3.1.2 Installation direction
The inverter may be installed on the wall or in a cabinet.
The inverter must be installed in an upright position. Check the installation site according to the requirements
below. Refer to chapter Dimension Drawings in the appendix for frame details.
3.1.3 Installation manner
The inverter can be installed in wall mounting (for all frame sizes):
(1) Mark the hole location. The location of the holes is shown in the dimension drawings in the appendix.
(2) Fix the screws or bolts to the marked locations.
(3) Position the drive onto the wall.
(4) Tighten the screws in the wall securely.
Installation Guidelines
- Keep away from contaminative air, such as corrosive gas, oil mist and
flammable gas
- Ensure foreign objects, such as metal power, dust, oil, water can not enter
into the inverter (do not install the inverter on the flammable materials such
as wood)
- Keep away from direct sunlight, oil mist, steam and vibration environment
Below 1000m
If the sea level is above 1000m, please derate 1% for every additional 100m.
2
≤ 5.8m/s (0.6g)
The inverter should be installed on an upright position to ensure sufficient
cooling effect.
Figure 3-1 Installation manner
Conditions
13 - 104