Salicru CV10-002-S2 User Manual page 99

Note:
Select the resistor and power of the braking resistor according to the data SALICRU provided.
The braking resistor may increase the braking torque of the inverter. Above table is measured at 100% braking
torque, 10%, 50% and 80% braking usage rate, the user can select braking system according to actual working.
 Never use a brake resistor with a resistance below the minimum value specified
for the particular drive. The drive and the internal chopper are not able to handle the
overcurrent caused by the low resistance.
 Increase the power of the braking resistor properly in the frequent braking
situation (the frequency usage ratio is more than 10%).
C.8.2 Place the brake resistor
Install all resistors in a place where they will cool.
 The materials near the brake resistor must be non-flammable. The surface
temperature of the resistor is high. Air flowing from the resistor is of hundreds of
Celsius degrees. Protect the resistor against contact.
Only external braking resistor is needed in CV10.
Appendix C Peripherial options and parts 99 - 104