Salicru CV10-002-S2 User Manual page 44

Function
Name
code
QUICK/JOG
the shifting
sequence
P07.03
selection of
running
command
STOP/RST
P07.04
stop function
Displayed
P07.05 parameters 1
of running state
44 - 104
Detailed instruction of parameters
4: Clear UP/DOWN settings. Press QUICK/JOG to clear
the set value of UP/DOWN.
5: Coast to stop. Press QUICK/JOG to coast to stop.
6: Shift the running
QUICK/JOG to shift the running commands source
(Keypad- Terminal- Communication)
7: Quick commission mode (based on non-default
parameters)
Note: Press QUICK/JOG to shift between forward rotation
and reverse rotation, the inverter does not record the state
after shifting during powering off. The inverter will run
according to parameter P00.13 during next powering on.
When P07.02=6, set the shifting sequence of running
command channels.
0: Keypad control→terminals control →communication
control
1: Keypad control←→terminals control
2: Keypad control←→communication control
3: Terminals control←→communication control
Select the stop function by STOP/RST. STOP/RST is
effective in any state for the keypad reset.
0: Only valid for the panel control
1: Both valid for panel and terminals control
2: Both valid for panel and communication control
3: Valid for all control modes
0x0000~0xFFFF
BIT0: running frequency (Hz on)
BIT1: set frequency(Hz flickering)
BIT2: bus voltage (Hz on)
BIT3: output voltage(V on)
BIT4: output current(A on)
BIT5: running rotation speed (rpm on)
BIT6: output power(% on)
BIT7: output torque(% on)
BIT8: PID reference(% flickering)
BIT9: PID feedback value(% on)
commands source.
Default
Modify
value
Press
0
0
0x03FF
Function Parameters
○
○
○