Triggers For Automatic Update; Access Authentication With Http Server - AudioCodes Mediant 800B User Manual

User's Manual
File Type
SSL/TLS Certificate file

48.2.5 Triggers for Automatic Update

The Automatic Update feature can be triggered by the following:

Upon device startup (reset or power up). To disable this trigger, run the following CLI
command:
(config-system)# automatic-update
(automatic-update)# run-on-reboot off

Periodically:
•
Specified time of day (e.g., 18:00), configured by the ini file parameter
AutoUpdatePredefinedTime or CLI command configure system > automatic-
update > predefined-time.
•
Interval between Automatic Updates (e.g., every 60 minutes), configured by the
ini file parameter AutoUpdateFrequency or CLI command configure system >
automatic-update > update-frequency.

Centralized provisioning server request:
•
Upon receipt of an SNMP request from the provisioning server.
•
Upon receipt of a special SIP NOTIFY message from the provisioning server. The
NOTIFY message includes an Event header with the AudioCodes proprietary
value, "check-sync;reboot=false", as shown in the example below:
NOTIFY sip:<user>@<dsthost> SIP/2.0
To: sip:<user>@<dsthost>
From: sip:sipsak@<srchost>
CSeq: 10 NOTIFY
Call-ID: 1234@<srchost>
Event: check-sync;reboot=false
To enable the feature:
a.
b.
c.
To enable through CLI: configure voip > sip-definition advanced-settings > sip-
remote-reset.

48.2.6 Access Authentication with HTTP Server

You can configure the device to authenticate itself with the HTTP/S server. The device
authenticates itself by providing the HTTP/S server with its authentication username and
password. You can configure one of the following HTTP authentication schemes:
Version 7.2
Keywords for
Template File
sslc
Open the Gateway Advanced Settings page (Setup menu > Signaling &
Media tab > Gateway folder > Gateway Advanced Settings).
From the 'Remote Management by Notify' (EnableSIPRemoteReset) drop-
down list, select Enable:
Figure 48-2: Resetting Device by SIP NOTIFY
Click Apply.
cert.pem
cert<ID>.pem (for multi-certificate
system)
821 Mediant 800B Gateway & E-SBC
48. Automatic Provisioning
Value Replacing
<FILE> Placeholder