Ids Parameters - AudioCodes Mediant 800B User Manual

Parameter
[SSHServerPort]
SSH Admin Key
configure system > cli-settings
> ssh-admin-key
[SSHAdminKey]
Public Key
configure system > cli-settings
> ssh-require-public-key
[SSHRequirePublicKey]
Max Payload Size
ssh-max-payload-size
[SSHMaxPayloadSize]
Max Binary Packet Size
configure system > cli-settings
> ssh-max-binary-packet-size
[SSHMaxBinaryPacketSize]
Maximum SSH Sessions
configure system > cli-settings
> ssh-max-sessions
[SSHMaxSessions]
Enable Last Login Message
configure system > cli-settings
> ssh-last-login-message
[SSHEnableLastLoginMessage]
Max Login Attempts
configure system > cli-settings
> ssh-max-login-attempts
[SSHMaxLoginAttempts]

67.5.6 IDS Parameters

The Intrusion Detection System (IDS) parameters are described in the table below.
Parameter
Intrusion Detection
System (IDS)
enable-ids
[EnableIDS]
User's Manual
Defines the RSA public key for strong authentication for logging in
to the SSH interface (if enabled).
The value should be a base64-encoded string. The value can be a
maximum length of 511 characters.
Enables RSA public keys for SSH.

[0] = (Default) RSA public keys are optional if a value is
configured for the parameter SSHAdminKey.

[1] = RSA public keys are mandatory.
Note: To define the key size, use the TLSPkeySize parameter.
Defines the maximum uncompressed payload size (in bytes) for
SSH packets.
The valid value is 550 to 32768. The default is 32768.
Defines the maximum packet size (in bytes) for SSH packets.
The valid value is 582 to 35000. The default is 35000.
Defines the maximum number of simultaneous SSH sessions.
The valid range is 1 to 5. The default is 5.
Enables message display in SSH sessions of the time and date of
the last SSH login. The SSH login message displays the number of
unsuccessful login attempts since the last successful login.

[0] Disable

[1] Enable (default)
Note: The last SSH login information is cleared when the device is
reset.
Defines the maximum SSH login attempts allowed for entering an
incorrect password by an administrator before the SSH session is
rejected.
The valid range is 1 to 3. The default is 3.
Table 67-29: IDS Parameters
Enables the IDS feature.

[0] Disable (default)

[1] Enable
Note: For the parameter to take effect, a device reset is required.
1018
Mediant 800B Gateway & E-SBC
Description
Description
Document #: LTRT-10298