AudioCodes Mediant 800B User Manual page 1187

User's Manual
Parameter
[UseSourceNumberAsDisplayName]
Use Display Name as Source
Number
configure voip > sip-definition
settings > disp-name-as-src-nb
[UseDisplayNameAsSourceNumber]
ENUM Resolution
configure voip > sip-definition
settings > enum-service-domain
[EnumService]
Use Routing Table for Host Names
and Profiles
configure voip > sip-definition
settings > rte-tbl-4-host-names
[AlwaysUseRouteTable]
Version 7.2
Tel Display Name is used as the IP Display Name. If no
Display Name is received from the Tel side, the IP Display
Name remains empty.

[1] Yes = If a Tel Display Name is received, the Tel Source
Number is used as the IP Source Number and the Tel
Display Name is used as the IP Display Name. If no
Display Name is received from the Tel side, the Tel Source
Number is used as the IP Source Number and also as the
IP Display Name.

[2] Overwrite = The Tel Source Number is used as the IP
Source Number and also as the IP Display Name (even if
the received Tel Display Name is not empty).

[3] Original = Similar to option [2], except that the operation
is done before regular calling number manipulation.
Determines the use of Source Number and Display Name for
IP-to-Tel calls.

[0] No = (Default) If IP Display Name is received, the IP
Source Number is used as the Tel Source Number and the
IP Display Name is used as the Tel Display Name. If no
Display Name is received from IP, the Tel Display Name
remains empty.

[1] Yes = If an IP Display Name is received, it is used as
the Tel Source Number and also as the Tel Display Name,
and Presentation is set to Allowed (0). If no Display Name
is received from IP, the IP Source Number is used as the
Tel Source Number and Presentation is set to Restricted
(1).
For example: When 'From: 100 <sip:200@201.202.203.204>'
is received, the outgoing Source Number and Display Name
are set to '100' and the Presentation is set to Allowed (0).
When 'From: <sip:100@101.102.103.104>' is received, the
outgoing Source Number is set to '100' and the Presentation is
set to Restricted (1).
Defines the ENUM service for translating telephone numbers
to IP addresses or domain names (FQDN), for example,
e164.arpa, e164.customer.net, or NRENum.net.
The valid value is a string of up to 50 characters. The default
is "e164.arpa".
Note: ENUM-based routing is configured in the Tel-to-IP
Routing table using the "ENUM" string value as the destination
address to denote the parameter's value.
Determines whether to use the device's routing table to obtain
the URI host name and optionally, an IP profile (per call) even
if a Proxy server is used.

[0] Disable = (Default) Don't use the Tel-to-IP Routing
table.

[1] Enable = Use the Tel-to-IP Routing table.
Note:

The parameter appears only if the 'Use Default Proxy'
parameter is enabled.

The domain name is used instead of a Proxy name or IP
1187
67. Configuration Parameters Reference
Description
Mediant 800B Gateway & E-SBC