Viewing Static Routes Status - AudioCodes Mediant 800B User Manual

Table 58-1: Ethernet Port Information Table Description
Parameter
Port Name
Active
Speed
Duplex Mode
State
Group Member
58.4

Viewing Static Routes Status

You can view the status of static IP routes, configured in the Static Routes table (see
'Configuring Static IP Routing' on page 142) and routes through the Default Gateway.
The status of the static routes can be one of the following:

"Active": Static route is used by the device.

"Inactive": Static route is not used. When the destination IP address is not on the
same segment with the next hop, or the interface does not exist, the route state
changes to "Inactive".

To view the status of static IP routing:

Open the Static Route Status table (Monitor menu > Monitor tab > Network Status
folder > Static Route Status).
User's Manual
Displays the name of the port.
Displays whether the port is active ("Yes") or not ("No").
Displays the speed of the Ethernet port.
Displays whether the port is half- or full-duplex.
Displays the state of the port:

"Forwarding": Active port (data is being transmitted and received)

"Disabled": Redundancy port
Displays the Ethernet Group to which the port belongs.
Figure 58-1: Viewing Static Route Status
Mediant 800B Gateway & E-SBC
Description
878 Document #: LTRT-10298