AudioCodes Mediant 800B User Manual page 1174

Parameter
Play Ringback Tone to IP
configure voip > sip-definition
settings > play-rbt-2ip
[PlayRBTone2IP]
Play Local RBT on ISDN Transfer
play-l-rbt-isdn-trsfr
[PlayRBTOnISDNTransfer]
MFC R2 Category
mfcr2-category
[R2Category]
Tone Index Table
Tone Index
configure voip > gateway analog
tone-index
[ToneIndex]
User's Manual

The parameter is applicable only to digital interfaces.
Global parameter that enables the device to play a ringback
tone to the IP side for IP-to-Tel calls. You can also configure
this functionality per specific calls, using IP Profiles
(IpProfile_PlayRBTone2IP). For a detailed description of the
parameter and for configuring this functionality in the IP Profiles
table, see 'Configuring IP Profiles' on page 405.
Note:

If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls
associated with the IP Profile.
Determines whether the device plays a local ringback tone for
ISDN's Two B Channel Transfer (TBCT), Release Line Trunk
(RLT), or Explicit Call Transfer (ECT) call transfers to the
originator when the second leg receives an ISDN Alerting or
Progress message.

[0] Don't Play (default)

[1] Play
Note:

For Blind transfer, the local ringback tone is played to first
call PSTN party when the second leg receives the ISDN
Alerting or Progress message.

For Consulted transfer, the local ringback tone is played
when the second leg receives ISDN Alerting or Progress
message if the Progress message is received after a SIP
REFER.

The parameter is applicable only if the parameter
SendISDNTransferOnConnect is set to 1.

The parameter is applicable only to digital interfaces.
Defines the tone for MFC R2 calling party category (CPC). The
parameter provides information on the calling party such as
National or International call, Operator or Subscriber and
Subscriber priority.
The value range is 1 to 15 (defining one of the MFC R2 tones).
The default is 1.
Note: The parameter is applicable only to digital interfaces.
Defines distinctive ringing and call waiting tones per FXS
endpoint (or for a range of FXS endpoints).
The format of the ini file table parameter is as follows:
[ToneIndex]
FORMAT ToneIndex_Index = ToneIndex_FXSPort_First,
ToneIndex_FXSPort_Last, ToneIndex_SourcePrefix,
ToneIndex_DestinationPrefix, ToneIndex_PriorityIndex;
[\ToneIndex]
For example, the configuration below plays the tone Index #3 to
FXS ports 1 and 2 if the source number prefix of the received
call is 20.
ToneIndex 1 = 1, 2, 20*, , 3;
For a detailed description of the table, see Configuring FXS
1174
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10298