Starting And Stopping Test Calls; Viewing Test Call Status; Viewing Test Call Statistics - AudioCodes Mediant 800B User Manual

Parameter
Schedule Interval
schedule-interval
[Test_Call_ScheduleInterval]
64.2

Starting and Stopping Test Calls

The following procedure describes how to start, stop, and restart test calls.

To start, stop, and restart a test call:
1. In the Test Call Rules table, select the required test call entry.
2. From the Action drop-down list, choose the required command:
•
Dial: Starts the test call (applicable only if the test call party is the caller).
•
Drop Call: Stops the test call.
•
Restart: Ends all established calls and then starts the test call session again.
64.3

Viewing Test Call Status

You can view the status of test call rules in the 'Test Status' field of the Test Call Rules
table. The status can be one of the following:
Status
"Idle" Test call is not active.
"Scheduled" Test call is planned to run (according to the 'Schedule Interval' parameter).
"Running" Test call has been started (i.e., by clicking Dial from the 'Action' drop-down list).
"Receiving": Test call has been automatically activated by calls received from the remote
endpoint for the test call endpoint (when all these calls end, the status returns to
"Idle").
"Terminating" Test call is in the process of terminating currently established calls (when Drop
Call is clicked from the 'Action' drop-down list to stop the test).
"Done" Test call has successfully completed (or was prematurely stopped by clicking the
Drop Call from the 'Action' drop-down list).
64.4

Viewing Test Call Statistics

You can view statistical information on the test call.

To view statistics of a test call:
1. In the Test Call Rules table, select the required test call row.
2. Scroll down the page to the area below the table. Statistics of the selected test call are
User's Manual
Defines the interval (in minutes) between automatic outgoing test
calls.
The valid value range is 0 to 100000. The default is 0 (i.e.,
scheduling is disabled).
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
Table 64-2: Test Call Status Description
956
Mediant 800B Gateway & E-SBC
Description
Description
Document #: LTRT-10298