AudioCodes Mediant 800B User Manual page 480

3. Configure a Trunk Group according to the parameters described in the table below.
4. Click Apply.
Table 22-2: Trunk Group Settings Table Parameter Descriptions
Parameter
General
Index
[TrunkGroupSettings_Index]
Name
trunk-group-name
[TrunkGroupSettings_TrunkG
roupName]
Trunk Group ID
trunk-group-id
[TrunkGroupSettings_TrunkG
roupId]
Channel Select Mode
channel-select-mode
[TrunkGroupSettings_Channe
lSelectMode]
User's Manual
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines an arbitrary name to easily identify the row.
The valid value can be a string of up to 40 characters. By default, no
name is configured.
The name also represents the Trunk Group in the SIP 'tgrp'
parameter in outgoing INVITE messages (according to RFC 4904) if
the UseSIPtgrp or UseBroadsoftDTG parameter is enabled. For
example, if you configure the parameter to "ITSP-ABC":
sip:+16305550100;tgrp=ITSP-ABC;trunk-context=+1-
630@isp.example.net;user=phone
If the parameter is not configured, the Trunk Group number is used in
the 'tgrp' parameter, for example:
sip:+16305550100;tgrp=TG-1;trunk-context=+1-
630@isp.example.net;user=phone
Note: Each row must be configured with a unique name.
Defines the Trunk Group ID that you want to configure.
Defines the method by which IP-to-Tel calls are assigned to the
channels of the Trunk Group.

[0] By Dest Phone Number = The channel is selected according to
the called (destination) number. If the number is not located, the
call is released. If the channel is unavailable (e.g., busy), the call
is put on call waiting (if call waiting is enabled and no other call is
on call waiting); otherwise, the call is released.

[1] Channel Cyclic Ascending = The next available channel in the
Trunk Group, in ascending cyclic order is selected. After the
480
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10298