AudioCodes Mediant 800B User Manual page 1097

User's Manual
Parameter
Enable SMDI
configure voip > gateway voice-mail-
setting > enable-smdi
[SMDI]
SMDI Timeout
configure voip > gateway voice-mail-
setting > smdi-timeout-[msec]
[SMDITimeOut]
Message Waiting Indication (MWI) Parameters
MWI Off Digit Pattern
configure voip > gateway voice-mail-
setting > mwi-off-dig-ptrn
[MWIOffCode]
MWI On Digit Pattern
configure voip > gateway voice-mail-
setting > mwi-on-dig-ptrn
[MWIOnCode]
MWI Suffix Pattern
configure voip > gateway voice-mail-
setting > mwi-suffix-pattern
[MWISuffixCode]
MWI Source Number
configure voip > gateway voice-mail-
setting > mwi-source-number
[MWISourceNumber]
configure voip > gateway dtmf-supp-
service supp-service-settings > mwi-
subs-ipgrpid
[MWISubscribeIPGroupID]
Version 7.2
67. Configuration Parameters Reference
Enables Simplified Message Desk Interface (SMDI) interface
on the device.

[0] Disable = (Default) Normal serial

[1] Enable (Bellcore)

[2] Ericsson MD-110

[3] NEC (ICS)
Note:

For the parameter to take effect, a device reset is
required.

When the RS-232 connection is used for SMDI
messages (Serial SMDI), it cannot be used for other
applications, for example, to access the Command Line
Interface (CLI).
Defines the time (in msec) that the device waits for an SMDI
Call Status message before or after a Setup message is
received. The parameter synchronizes the SMDI and analog
CAS interfaces.
If the timeout expires and only an SMDI message is
received, the SMDI message is dropped. If the timeout
expires and only a Setup message is received, the call is
established.
The valid range is 0 to 10000 (i.e., 10 seconds). The default
is 2000.
Defines the digit code used by the device to notify the PBX
that there are no messages waiting for a specific extension.
This code is added as prefix to the dialed number.
The valid range is a 25-character string.
Defines the digit code used by the device to notify the PBX
of messages waiting for a specific extension. This code is
added as prefix to the dialed number.
The valid range is a 25-character string.
Defines the digit code used by the device as a suffix for
'MWI On Digit Pattern' and 'MWI Off Digit Pattern'. This suffix
is added to the generated DTMF string after the extension
number.
The valid range is a 25-character string.
Defines the calling party's phone number used in the Q.931
MWI Setup message to PSTN. If not configured, the
channel's phone number is used as the calling number.
Defines the IP Group ID used when subscribing to an MWI
server. The 'The SIP Group Name' field value of the IP
Groups table is used as the Request-URI host name in the
outgoing MWI SIP SUBSCRIBE message. The request is
sent to the IP address defined for the Proxy Set that is
associated with the IP Group. The Proxy Set's capabilities
1097
Description
Mediant 800B Gateway & E-SBC