Isdn Bri Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
configure voip >
interface fxs-fxo > wink-
time
[WinkTime]
67.11.5.13

ISDN BRI Parameters

The ISDN BRI call forwarding service parameters are described in the table below.
Parameter
BRI-to-SIP Supplementary Services Codes for Call Forward
For more information, see 'BRI Call Forwarding' on page 554.
Call Forward Unconditional
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-code
[SuppServCodeCFU]
Call Forward Unconditional
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-
deactivation-code
[SuppServCodeCFUDeact]
Call Forward on Busy
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-code
[SuppServCodeCFB]
Call Forward on Busy
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-
deactivation-code
[SuppServCodeCFBDeact]
Version 7.2
Defines the time (in msec) elapsed between two consecutive polarity
reversals. The parameter can be used for DID signaling, for example,
E911 lines to the Public Safety Answering Point (PSAP), according to the
Bellcore GR-350-CORE standard (refer to the ini file parameter
Enable911PSAP).
The valid range is 0 to 4,294,967,295. The default is 200.
Note: For the parameter to take effect, a device reset is required.
Table 67-56: BRI Call Forwarding Services Parameters
Defines the prefix code for activating Call Forward Unconditional sent
to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., '*72').
Defines the prefix code for deactivating Call Forward Unconditional
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., '*72').
Defines the prefix code for activating Call Forward on Busy sent to the
softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., '*72').
Defines the prefix code for deactivating Call Forward on Busy
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., '*72').
67. Configuration Parameters Reference
Description
Description
1125 Mediant 800B Gateway & E-SBC