AudioCodes Mediant 800B User Manual page 1154

Parameter
Remove CLI when Restricted
rmv-cli-when-restr
[RemoveCLIWhenRestricted]
Remove Calling Name
rmv-calling-name
[RemoveCallingName]
Remove Calling Name
configure voip > interface bri
> rmv-calling-name
[RemoveCallingNameForTrun
k_x]
Progress Indicator to ISDN
configure voip > interface e1-
t1|bri > pi-to-isdn
[ProgressIndicator2ISDN_x]
Set PI in Rx Disconnect
User's Manual
User=043030373435313734313635353b313233343b3834;
encoding=hex
where "04" at the beginning of this message is the pd.

[3] = Interworks the SIP User-to-User header containing text
format to ISDN UUIE in hexadecimal format, and vice versa. For
example:
SIP Header in text format:
User-to-User=01800213027b712a;NULL;4582166;
Translated to hexadecimal in the ISDN UUIE:
303138303032313330323762373132613b4e554c4c3b34353
8323136363b
The Protocol Discriminator (pd) used in UUIE is "04" (IUA
characters).
Note: The parameter is applicable for Tel-to-IP and IP-to-Tel calls.
Determines (for IP-to-Tel calls) whether the Calling Number and
Calling Name IEs are removed from the ISDN Setup message if the
presentation is set to Restricted.

[0] No = (Default) IE's are not removed.

[1] Yes = IE's are removed.
Enables the device to remove the Calling Name from SIP-to-ISDN
calls for all trunks.

[0] Disable = (Default) Does not remove Calling Name.

[1] Enable = Removes Calling Name.
Note: Some PSTN switches / PBXs may not be configured to support
the receipt of the "Calling Name" information. These switches might
respond to an ISDN Setup message (including the Calling Name)
with an ISDN "REQUESTED_FAC_NOT_SUBSCRIBED" failure. The
parameter can be set to Enable (1) to remove the "Calling Name"
from SIP-to-ISDN calls and allow the call to proceed.
Enables the device to remove the Calling Name for SIP-to-ISDN
calls, per trunk.

[-1] Use Global Parameter = (Default) Settings of the global
parameter RemoveCallingName are used.

[0] Disable = Does not remove Calling Name.

[1] Enable = Remove Calling Name.
Note: The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Determines the Progress Indicator (PI) to ISDN per trunk.

[-1] Not Configured = (Default) The PI in ISDN messages is set
according to the parameter PlayRBTone2Tel.

[0] No PI = PI is not sent to ISDN.

[1] PI = 1; [8] PI = 8: The PI value is sent to PSTN in
Q.931/Proceeding and Alerting messages. Typically, the
PSTN/PBX cuts through the audio channel without playing local
ringback tone, enabling the originating party to hear remote Call
Progress Tones or network announcements.
Note: The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Defines the device's behavior per trunk when a Disconnect message
1154
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10298