AudioCodes Mediant 800B User Manual page 862

Note:
•
The PacketSmart feature is a license-dependent feature and is available only if it
is included in the License Key installed on the device. For ordering the feature,
please contact your AudioCodes sales representative.
•
Before configuring the PacketSmart agent, configure the following:
√
Correct data and time of the device. It is recommended to use an NTP server to
obtain the date and time (see 'Configuring Automatic Date and Time using
SNTP' on page 119).
√
IP network interface for communicating with the PacketSmart server. Typically,
the OAMP interface is used. To configure IP network interfaces, see
'Configuring IP Network Interfaces' on page 135.
√
IP network interface for the VoIP traffic that you want monitored by
PacketSmart.
•
For detailed information on setting up the PacketSmart solution, refer to the
document, Mediant Gateways and SBCs with BroadCloud PacketSmart
Configuration Note.
The following procedure describes how to configure PacketSmart through the Web
interface. You can also configure it through ini file or CLI (configure system > packetsmart).

To configure the PacketSmart agent:
1. Open the Network Settings page (Setup menu > IP Network tab > Advanced folder >
Network Settings).
2. From the 'PacketSmart Agent Mode' drop-down list, select Enable to enable the
feature.
3. Configure the remaining parameters, as required. For parameter descriptions, see
'PacketSmart Parameters' on page 1007.
The following read-only fields are displayed:
•
'ID': Displays the name and serial number of the PacketSmart agent (i.e., the
device) on the PacketSmart server.
•
'Platform': Displays the name of the device.
4. Click Submit, and then reset the device with a save-to-flash for your settings to take
effect.
User's Manual
Figure 55-6: Configuring PacketSmart Agent
862
Mediant 800B Gateway & E-SBC
Document #: LTRT-10298