Metering Tone Parameters - AudioCodes Mediant 800B User Manual

Parameter
udt-detector-frequency-deviation
[UDTDetectorFrequencyDeviation]
cpt-detector-frequency-deviation
[CPTDetectorFrequencyDeviation]
67.11.9.3

Metering Tone Parameters

The metering tone parameters are described in the table below.
Parameter
Generate Metering Tones
configure voip > gateway
analog metering-tones >
gen-mtr-tones
[PayPhoneMeteringMode]
User's Manual

For the parameter to take effect, a device reset is required.

The IP-to-ISDN call is disconnected on detection of a SIT
tone only in call alert state. If the call is in connected state, the
SIT does not disconnect the call. Detection of busy or reorder
tones disconnect these calls also in call connected state.

For IP-to-CAS calls, detection of busy, reorder, or SIT tones
disconnect the call in any call state.
Defines the deviation (in Hz) allowed for the detection of each
signal frequency.
The valid range is 1 to 50. The default is 50.
Note: For the parameter to take effect, a device reset is required.
Defines the deviation (in Hz) allowed for the detection of each
CPT signal frequency.
The valid range is 1 to 30. The default is 10.
Note: For the parameter to take effect, a device reset is required.
Table 67-66: Metering Tone Parameters
Defines the method for configuring metering tones that are generated to
the Tel side.

[0] Disable = (Default) Metering tones are not generated.

[1] Table Code Table = Metering tones are generated by the device
according to the Charge Code table (see Configuring Charge Codes
on page 580) and sent to the Tel side.

[2] SIP Interval Provided = (Proprietary method of TELES
Communications Corporation) Advice-of-Charge service toward the
PSTN. Periodic generation of AOC-D and AOC-E toward the PSTN.
Calculation is based on seconds. The time interval is calculated
according to the scale and tariff provided in the proprietary formatted
file included in SIP INFO messages, which is always sent before 200
0K. The device ignores tariffs sent after the call is established.
(Applicable only to digital interfaces.)

[3] SIP RAW Data Provided = (Proprietary method of Cirpack) Advice-
of-Charge service toward the PSTN. The received AOC-D messages
contain a subtotal. When receiving AOC-D in raw format, provided in
the header of SIP INFO messages, the device parses AOC-D raw
data to obtain the number of units. This number is sent in the Facility
message with AOC-D. In addition, the device stores the latest number
of units in order to send them in AOC-E IE when the call is
disconnected. (Applicable only to digital interfaces.)

[4] SIP RAW Data Incremental Provided = (Proprietary method of
Cirpack) Advice-of-Charge service toward the PSTN. The AOC-D
message in the payload is an increment. When receiving AOC-D in
raw format, provided in the header of SIP INFO messages, the device
parses AOC-D raw data to obtain the number of units. This number is
sent in the Facility message with AOC-D. The device generates the
1176
Mediant 800B Gateway & E-SBC
Description
Description
Document #: LTRT-10298