Tdm Bus And Clock Timing Parameters - AudioCodes Mediant 800B User Manual

Parameter
[TDMHairPinningAlarmIndication] Enables two trunks that are connected through TDM hairpinning
Enable TDM Tunneling
tdm-tunneling
[EnableTDMoverIP]
iso8859-charset
[ISO8859CharacterSet]
67.11.6.2

TDM Bus and Clock Timing Parameters

The TDM Bus parameters are described in the table below.
Table 67-59: TDM Bus and Clock Timing Parameters
Parameter
TDM Bus Parameters
User's Manual

For the parameter to take effect, a device reset is required.

The parameter is applicable only to PRI.
to signal the Far-End about the presence of PSTN alarms. When
the trunk with TDM hairpinning receives a PSTN alarm, its'
connected trunk sends an AIS alarm to its' Far-End.

[0] = (Default) Disable

[1] = Enable
Note:

For the parameter to take effect, a device reset is required.

The parameter is applicable only to PRI.
Enables TDM tunneling.

[0] Disable (default)

[1] Enable
Note:

For the parameter to take effect, a device reset is required.

The parameter is applicable only to PRI.

For an overview on TDM tunneling, see TDM Tunneling on
page 466.
Defines the ISO 8859 character set type (languages) for
representing the alphanumeric string of the calling name (caller
ID) in the forwarded message, for IP-to-Tel and Tel-to-IP calls.

[0] No Accented = Proprietary method where incoming INVITE
messages with any accented characters (e.g., á, é, í, ó, and ü),
which are represented in a 2-byte unicode character, are
translated to Latin-only, which are normal one-byte ASCII
characters (a, e, i, o, and u, respectively).

[1] Western European (Default)

[2] Central European

[3] South European

[4] North European

[5] Cyrillic

[6] Arabic

[7] Hebrew

[8] Turkish
1132
Mediant 800B Gateway & E-SBC
Description
Description
Document #: LTRT-10298