AudioCodes Mediant 800B User Manual page 440

The following procedure describes how to configure Tel Profiles through the Web interface.
You can also configure it through ini file (TelProfile) or CLI (configure voip/coders-and-
profiles tel-profile).

To configure a Tel Profile:
1. Open the Tel Profiles table (Setup menu > Signaling & Media tab > Coders &
Profiles folder > Tel Profiles).
2. Click New; the following dialog box appears:
3. Configure a Tel Profile according to the parameters described in the table below. For a
description of each parameter, refer to the corresponding "global" parameter.
4. Click Apply.
Table 19-6: Tel Profile Table Parameters and Corresponding Global Parameters
Tel Profile Parameter
General
Index
[TelProfile_Index]
Name
profile-name
[TelProfile_ProfileName]
Signaling
Profile Preference
tel-preference
[TelProfile_TelPreference]
User's Manual
Figure 19-9: Tel Profiles Table - Add Dialog Box
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines an arbitrary name to easily identify the row.
The valid value is a string of up to 20 characters.
Defines the priority of the Tel Profile, where 1 is the lowest priority and 20 the
highest priority.
Note:

If both the IP Profile and Tel Profile apply to the same call, the
coders and common parameters of the Preferred profile are
applied to the call.

If the Preference of the Tel Profile and IP Profile are identical,
the Tel Profile parameters are applied.

If the coder lists of both the IP Profile and Tel Profile apply to
Mediant 800B Gateway & E-SBC
Global Parameter
440 Document #: LTRT-10298