AudioCodes Mediant 800B User Manual page 1103

User's Manual
Parameter
caller-id-timing-mode
[AnalogCallerIDTimingMode]
configure voip > interface fxs-fxo >
bellcore-callerid-type-one-sub-
standard
[BellcoreCallerIDTypeOneSubSta
ndard]
configure voip > interface fxs-fxo >
etsi-callerid-type-one-sub-
standard
[ETSICallerIDTypeOneSubStanda
rd]
Asserted Identity Mode
asserted-identity-m
[AssertedIdMode]
Version 7.2

[0] = (Default) Caller ID is generated between the first two
rings.

[1] = The device attempts to find an optimized timing to
generate the Caller ID according to the selected Caller ID
type.
Note:

The parameter is applicable only to FXS interfaces.

If the parameter is set to 1 and used with distinctive ringing,
the Caller ID signal doesn't change the distinctive ringing
timing.

For the parameter to take effect, a device reset is required.
Determines the Bellcore Caller ID sub-standard.

[0] = (Default) Between rings.

[1] = Not ring related.
Note:

For the parameter to take effect, a device reset is required.

The parameter is applicable only to FXS interfaces.
Determines the ETSI FSK Caller ID Type 1 sub-standard (FXS
only).

[0] = (Default) ETSI between rings.

[1] = ETSI before ring DT_AS.

[2] = ETSI before ring RP_AS.

[3] = ETSI before ring LR_DT_AS.

[4] = ETSI not ring related DT_AS.

[5] = ETSI not ring related RP_AS.

[6] = ETSI not ring related LR_DT_AS.
Note:

For the parameter to take effect, a device reset is required.

The parameter is applicable only to FXS interfaces.
Determines whether the SIP header P-Asserted-Identity or P-
Preferred-Identity is added to the sent INVITE, 200 OK, or
UPDATE request for Caller ID (or privacy). These headers are
used to present the calling party's Caller ID, which is composed
of a Calling Number and a Calling Name (optional).

[0] Disabled = (Default) P-Asserted-Identity and P-Preferred-
Identity headers are not added.

[1] Add P-Asserted-Identity

[2] Add P-Preferred-Identity
The used header also depends on the calling Privacy (allowed or
restricted). These headers are used together with the Privacy
header. If Caller ID is restricted (i.e., P-Asserted-Identity is not
sent), the Privacy header includes the value 'id' ('Privacy: id').
Otherwise, for allowed Caller ID, 'Privacy: none' is used. If Caller
ID is restricted (received from Tel or configured in the device),
the From header is set to <anonymous@anonymous.invalid>.
For Digital Interfaces: The 200 OK response can contain the
connected party CallerID - Connected Number and Connected
Name. For example, if the call is answered by the device, the
1103
67. Configuration Parameters Reference
Description
Mediant 800B Gateway & E-SBC