Filtering Ip Network Traces - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
Log Type
log-type
[LoggingFilters_CaptureType]
Mode
mode
[LoggingFilters_Mode]

60.1.1 Filtering IP Network Traces

You can filter Syslog and debug recording messages for IP network traces, by configuring
the 'Filter Type' parameter to IP Trace in the Logging Filters table. IP traces are used to
record any IP stream, according to destination and/or source IP address, or port and Layer-
4 protocol (UDP, TCP or any other IP type as defined by http://www.iana.com). Network
traces are typically used to record HTTP.
When the IP Trace option is selected, only the 'Value' parameter is applicable; the 'Syslog'
and 'Capture Type' parameters are not relevant. The 'Value' parameter configures the
Version 7.2
Defines the type of messages to include in the log file.

[0] = (Default) Not configured. The option is applicable only for
sending Syslog messages to a Syslog server (i.e., 'Log
Destination' parameter is configured to Syslog Server).

[1] Signaling = The option is applicable only to debug recording
(i.e., 'Log Destination' parameter is configured to Debug
Recording Server). The debug recording includes signaling
information such as SIP signaling messages, Syslog messages,
CDRs, and the device's internal processing messages.

[2] Signaling & Media = The option is applicable only to debug
recording (i.e., 'Log Destination' parameter is configured to
Debug Recording Server). The debug recording includes
signaling, Syslog messages, and media (RTP/RTCP/T.38).

[3] Signaling & Media & PCM = The option is applicable only to
debug recording (i.e., 'Log Destination' parameter is configured
to Debug Recording Server). The debug recording includes
signaling, Syslog messages, media, and PCM (voice signals
from and to TDM).

[4] PSTN Trace = The option is applicable only to debug
recording (i.e., 'Log Destination' parameter is configured to
Debug Recording Server) and if the 'Filter Type' parameter is
configured to Trunk ID. The debug recording includes ISDN and
CAS traces.

[5] CDR Only = Only CDRs are generated. The option is
applicable only if the 'Log Destination' parameter is configured to
Syslog Server or Local Storage. When configured to Syslog
Server, only CDRs are included in the Syslog messages
(excluding all system logs and alerts) sent to the Syslog server.
Note:

If you configure the 'Log Destination' parameter to Local
Storage, the 'Log Type' parameter must be configured to CDR
Only.

The parameter is not applicable when the 'Filter Type' parameter
is configured to IP Trace.

To include Syslog messages in debug recording, it is
unnecessary to enable Syslog functionality.
Enables and disables the rule.

[0] Disable

[1] Enable (default)
929
60. Syslog and Debug Recording
Description
Mediant 800B Gateway & E-SBC